How To Repair Drywall (2)

When you are planning a remodeling project for your home there is a quantity of factors you want to look for from your potential contractor. Subsequent, location the drywall patch over the hole in the wall and trace the shape on the wall with a pencil. To repair a hole in your wall normally needs some variety of patch to cover the hole, whether it is a metal patch like the a single I’m holding here, or yet another piece of drywall like this. Repairing a hole in your drywall could appear like a challenge if you’ve never completed it before.

If there are no electrical or plumbing lines present, use a drywall saw to punch a hole via the drywall along your line. Drive a drywall screw 1 1/2 inches above the popped nail head into the stud to reattach the drywall to the stud. Apply a thin layer of drywall compound to the seams and cover with mesh tape, bedding the tape in the drywall compound.

Use a drywall knife to cover the patch with lightweight joint compound in a crisscross pattern, feathering the edges so it blends with the wall. To feather the edge, improve pressure and angle on the drywall knife as you reach the outer edges of the patch area to lessen, or thin, the joint compound on the drywall. Whether you are employing drywall compound, spackling or painters’ putty, they all have a tendency to shrink as they dry, so you will want to repeat the method many occasions prior to the hole is effectively filled. Sink the screw head just under the surface of the drywall so it can be covered with spackle.

READ  How To Patch And Repair Drywall (3)

In addition to the patch, you need to have drywall patching compound to smooth out the patch and a putty knife to spread the drywall compound more than the patch. If water harm has brought on a drywall ceiling to sag, reattach it along the seam by pressing up and nailing the drywall to the joist. Employing a putty knife, spread drywall compound more than the whole patch, feathering out the edges beyond the patch onto the wall. Very first, reduce a piece of drywall that is slightly larger than the hole you are attempting to repair. Now, screw your drywall patch to the wooden cleats, once more being cautious not to break the drywall’s paper coating.

For a knock-down finish – one exactly where a trowel presses joint compound down to type a texture that’s much more mottled than a flat wall – lightly flatten the particles with a knife as the compound mixture starts to dry. To reduce the drywall, you can either cut it with the drywall saw or use a blade knife to score and snap it, scoring the front employing the blade knife and a straight edge, then snapping it in two pieces.